Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 GM; Door Lock Gasket; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1952-66 Chevrolet/GMC Pickup Outer Door Handle Gasket Set
Reproduction of the original door handle pads for 1952-66 Chevrolet and GMC trucks. This set is for a two handles to both sides. One set is required per vehicle. Note: For a half set that includes gaskets for a single door,...
1938-72 Chevrolet, GMC Pickup, Blazer, Jimmy, Suburban; Front Fender Welting; 25 Foot Roll
OER® reproduction of the original style front fender welting that seals the fender to the body on 1938-1972 Chevrolet and GMC truck models. This welting is essential when replacing the fenders, or simply restoring the...
1955-60 Buick, Chevy, Olds, Pontiac; Hood to Cowl Seal; with Clips; Various Models
Reproduction of the original hood to cowl seal designed for use on various 1955-60 GM models. Includes the hood to cowl seal and installation clips. This seal will keep rain and dirt from entering your engine compartment. A...