1956 and 1958 Chevrolet Passenger Car; Rear Bumper to Body Seal
Reproduction of the original rear bumper to body seal designed for 1956 and 1958 Chevrolet full size passenger car models. Each body seal is manufactured to factory specifications from molded EPDM rubber. {fitment}
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 GM; Door Lock Gasket; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1957-58 Chevrolet Full Size Passenger Car; Radiator Core Support Wiring Grommet
Reproduction radiator core grommet for 1957-58 Chevrolet passenger car models. This grommet is used to guide the wiring harness through the radiator core support and installs in the driver side of the core support panel....
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER
Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...