Product#: K4122

1947-2010 Windshield & Back Glass; Butyl Rubber Sealant Tape; 3/8" Diameter Round Ribbon; 15-Foot Roll

OER butyl rubber sealant for installing front windshield or back glass installation. Can be used on virtually all models of Chrysler, GM, and Ford that did not use a contoured molded style weatherstrip for installation of the...


Product#: 3864327

1965-72 GM; Wiring Harness Firewall Retainer Gutter; 13" Long; OER

Reproduction firewall wiring harness gutter for a wide variety of vehicles. This reproduction wire harness gutter holds the engine harness as it passes against the firewall area to protect the wiring harness as it crosses...


Product#: K1114

1937-80 GM, 1961-64 Impala, 1964-72 El Camino; Gas Door Bumpers; 1937-58 1-prong Door Bumpers; Pair

Correct reproduction rubber bumper for various GM applications. Fits: 1937-1958 GM full size vehicle door bumper, single prong style, front or rear. 1961-64 full size and 1964-72 El Camino gas filler door. Keeps the door from...


Product#: TF300249

1955-59 Truck, 1955 Car 4-Hole 1-5/8" OD Wire Harness Grommet (Large)

Reproduction of the large 4-hole firewall wire harness grommet for all 1955 Chevrolet cars and 1955-59 Chevrolet and GMC trucks. Can also be used for custom or as a universal fit grommet for other applications. Measures 1...


Product#: 4410574

Rubber Floor Pan Plug; 1-1/4" Diameter. Fits 1" Hole; Each

Reproduction rubber floor pan plug measures 1-1/4" diameter and fits a 1" hole. Sold individually, use as required.


Product#: TF300217

1957-59 Chevrolet Speedometer Cable Grommet

This grommet mounts on the firewall where the speedometer cable runs through it. Manufactured in automotive grade molded rubber. Replaces OE # 3781684. {fitment}


Product#: K2011

1958-59 Impala, Bel Air, Biscayne, El Camino; Rear Gas Filler Door Bumpers; Pair

Correct reproduction of the original gas filler door rubber bumper for use with 1958-59 Impala, Bel Air, Biscayne, and El Camino models. Each bumper is manufactured in EPDM rubber to original factory specifications. Keeps the...


Product#: WS516

1957-70 Buick, Cadillac, Chevy, Pontiac, Oldmobile; Trunk Weatherstrip; Various Full Size Models

Reproduction of the original trunk weatherstrip manufactured in the correct configuration. Prevent water damage in your trunk area by replacing the worn and damaged weatherstrip with this authentic reproduction. The soft...


Product#: A1031

Nylon Fastener; 13/64" Dia. Stem; 13/32" Stem Length; For Door/Header Weatherstrip; Natural

This reproduction door weatherstrip clip is used on most GM vehicles which require plastic push in clips. These hook into holes in the door rubber weatherstripping and hold the weatherstrip to the door. Also used on Most GM...


Product#: K4065

1949-58 Bel Air, 150, 210, Nomad, Impala, Bel Air, Biscayne; Door Bumpers; Pair; Various Models

Reproduction door rubber bumpers for 1949-1958 Chevrolet Bel Air, 150, 210, Impala, Bel Air, Biscayne, and various station wagon models. Designed to help keep your door aligned and in the correct position. Each bumper...


Product#: K2019

1955-57 Chevy Bel Air, 150, 210, Nomad; Upper Trunk lid, 1955-59 Rear License Plate Bumpers; Pair

Correct reproduction of the rubber bumper for the upper trunk on 1955-57 Chevrolet Bel Air, 150, 210, Nomad cars and the rear license plate on all 1955-59 Impala. Bel Air, Biscayne, El Camino, and station wagon models. Sold...


Product#: K2017

1955-81 Chevrolet, GMC, Pontiac; Air Cleaner Lid Rubber Seal; 59" Long x 5/16" Wide

Reproduction air cleaner lid seal for a variety of GM car and truck models as listed. Designed to seal the area between the lid and the base offering a tight seal for the air cleaner on models that required this seal. {specs}...


Product#: TF401018

1956 & 1958 Chevy Bel Air, 150, 210, Impala, Biscayne; Rear Bumper to Body Seal Weatherstrip

Reproduction of the original rear bumper to body seal designed for 1956 and 1958 Chevrolet full size passenger car models. Each body seal is manufactured to factory specifications from molded EPDM rubber. {fitment}


Product#: 4131052

1941-58 Chevrolet Passenger Car Sedan or Wagon; Door Window Stop

Reproduction lower, rubber window stop bumper for all models except hardtop and convertible. Measures 13/16" Wide 3/16" Tall. Fits most 1941-58 Chevrolet Cars. {fitment}


Product#: STAPLES

Staple For Inner Fender Splash Apron, 1/2 inch

Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.


Product#: 3792828

1942-77 GM; Hood Adjustment Rubber Bumpers; Round; Pair; Various Models

Reproduction hood adjustment bumpers for various 1942-77 GM models. These 7/8" OD reproduction stoppers are manufactured in quality rubber and designed to replace the worn out, deteriorated, or lost originals. Allows for a...


Product#: K940

1955-90 Buick, Chevrolet, Pontiac, Oldsmobile; Door Lock Gasket; Each; Various Models

Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...


Product#: K551

1958-77 Buick, Chevy, Olds, Pontiac; Hood Adjust Bumper and Screw Set; Various Models

Reproduction hood adjustment bumpers for various 1958-77 GM models including 1967-69 Camaro and Firebird models. These 7/8" OD reproduction stoppers and screws are manufactured to original specifications to replace the worn...


Product#: 1667195

1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each

Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...


Product#: GT8834

Sealstrip Glass Setting Tape; 10 Foot Roll; 1/32" Tape Thickness

Replacement glass setting tape for various models. This glass tape holds glass firmly and permanently. Seals against dirt, moisture, and will not stretch out of shape. Just fold it over the glass edge, insert glass in the...


Product#: TF300219

1957-58 Chevrolet Bel Air, 150, 210, Nomad; Radiator Core Support Wiring Grommet

High-quality reproduction radiator core grommet designed for 1957-58 Chevrolet passenger car models. This grommet routes and protects the wiring harness as it passes through the radiator core support, preventing abrasion and...


Product#: 3868790

1955-1981 GM; Firewall Pad Fastener; Each

This reproduction firewall pad fastener is designed to hold the firewall insulation pad in place on various 1955-81 General Motors models. Each fastener is manufactured from EPDM rubber replicating the original configuration...


Product#: 3743360

1958-75 Clutch Bellcrank Felt Seals ; Pair

OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...


Product#: W1224

1955-58 GM Full Size; Vent Window Bumper Stops; Upper; Pair

Reproductions of the original upper vent window bumpers designed for use on 1955-58 GM Full Size models. Upper vent window bumpers are manufactured to replicate the original design and fit. Includes molded rubber design with...


Product#: 748621

1967-69 Camaro, Firebird; Plastic Clip Set; Radiator Support To Hood Seal; 9 Piece Set

Reproduction of the radiator support to hood seal clip set designed for 1967-69 Camaro and Firebird models with air conditioning. Each clip is injection molded to original specifications. Clips are designed to hold the hood...


Product#: A4250

1938-91 GM; Consol & Glove Box Rubber Stoppers; Fits 1/4" Hole; Pair

Eliminate the rattling and looseness of the glove box or console door by simply replacing worn out or missing rubber stoppers with these high quality reproduction rubber stoppers. Designed for use with a variety of 1938-1991...


Product#: K8100

1955-58 Buick, Cadillac, Chevy, Pontiac, Olds; Windshield Pillar Post Weatherstrip; Pair

Reproduction of the original pillar post weatherstripping designed for use on various 1955-58 Buick, Cadillac, Chevy, Pontiac, and Oldsmobile models including 1955-57 Bel Air and full size Chevrolets. Replacing the windshield...


Product#: BC1028

1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER

Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...


Product#: K9801

1958-64 Impala, Bel Air; Quarter Window Vertical Weatherstrip; 2 Door; Hardtop, Convertible

Reproduction of the original quarter window vertical weatherstripping designed for 1958-64 Impala, Bel Air, Electra, Le Sabre, El Dorado, and other Full Size GM models as listed. This high quality reproduction is manufactured...