1967-69 Camaro, Firebird; Convertible Top Boot Clip; Each

Correct reproduction top boot clips for 1967-69 Camaro and Firebird convertible models. These clips are specifically designed to hold the top boot to the convertible well molding when the convertible top is in the down position. Each clip attaches to the convertible top boot inner plastic insert and snaps onto the outer molding to secure the boot in place. Each injection molded top boot clip is manufactured with durable glass filled nylon for a stronger and longer lasting design than the original GM clips. The metal clip and attaching yoke are produced to exact specifications using treated spring steel. Camaro and Firebird convertibles require 16 clips per vehicle. For a complete set of 16 clips, refer to part number K52010.

• Accurate reproduction of original GM convertible top boot clips
• Glass filled nylon construction provides superior strength and durability
• Spring steel components manufactured to factory specifications
• Securely holds the convertible top boot in place when the top is down
• Restores proper function and original appearance

• Material: Glass filled nylon with treated spring steel components
• Quantity required: 16 per vehicle
• Sold individually - full set requires 16 clips
• For complete 16-piece set, see part number K52010

• 1967 - 1969 Chevrolet Camaro Base
• 1967 - 1969 Chevrolet Camaro RS
• 1967 - 1969 Chevrolet Camaro SS

• 1967 - 1969 Pontiac Firebird Base
• 1969 - 1969 Pontiac Firebird Trans Am
• 1967 - 1967 Pontiac Firebird HO
• 1967 - 1969 Pontiac Firebird Sprint
• 1967 - 1969 Pontiac Firebird 400
• 1968 - 1969 Pontiac Firebird 350
• 1969 - 1969 Pontiac Firebird 350 HO

Top Boot Clip Installation Instructions:

• 1) Attach the top boot clip to the sewn-in inner plastic insert on the reverse side of the top boot. The plastic top boot clip is held on using the U-shaped retainer that comes in the kit. Pre-existing holes are die-cut in the plastic insert allowing installation of the clips.
• 2) Push the plastic clip into the cut-out area, and slide the U-shape retainer over the top boot clip on the opposite side of the plastic insert.
• 3) Your top boot clip should be securely fastened to the plastic insert. Repeat this process for all 16 clips. Once installation of the top boot clips is complete, the clips will remain attached to the boot for multiple on-and-off installations of the top boot.
• 4) Once the convertible top is in the "down" position, the top boot can attach to the convertible well molding that runs around the convertible well. The top boot can be installed and removed from the vehicle multiple times without removing the top boot clips.